Abstract：In order to study the radial force of nuclear main pump, the prototype pump and the offset of the center of gravity of the nuclear main pumps had been investigated numerically by CFD calculation based on the RNG k-ε model. Results of performance of the nuclear main pumps, distribution of static pressure at the center section and the radial force features acting in the volute and impeller features had been obtained from the simulation, and were compared with the theoretical analysis. The results showed that the test results and numerical calculation were in good agreement in this paper thus the results of numerical calculation of radial force calculation model for nuclear main pump has certain accuracy. There is no great difference in distribution of static pressure within four schemes in the impeller and guide vane, but in the volute varies obviously, the static pressure distribution of different eccentricity were asymmetric, and the change of eccentricity had a certain influence on the internal and external performances of nuclear main pump. The radial force of nuclear main pump was minimum when it operated at the design point, but not equal to zero,the radial force was optimum when the eccentricity were 10 millimeter. By comparing the predicted radial force and the Stepanoff theoretical ones under different eccentricities it could be known that, the curves trend of the radial force under different eccentricities were consistent with the theoretical ones and the method of the numerical simulation verified the accuracy of the radial force calculated by the empirical formula.
王鹏, 袁寿其, 王秀礼, 尹庭赟. 偏心距对核主泵径向力影响的数值分析[J]. 排灌机械工程学报, 2015, 33(6): 461-466.
Wang Peng, Yuan Shouqi, Wang Xiuli, Yin TingYun. Numerical analysis on effects of nuclear main pump radial force under different eccentricities. Journal of Drainage and Irrigation Machinery Engin, 2015, 33(6): 461-466.
[1]杨敏,闵思明,王福军.双蜗壳泵压力脉动特性及叶轮径向力数值模拟[J].农业机械学报,2009,40(11): 83-88. Yang Min,Min Siming,Wang Fujun. Numerical simulation of pressure fluctuation and radial force in a double volute pump[J]. Transactions of the Chinese Society for Agricultural Machinery,2009,40(11): 83-88.(in Chinese)[2]赵万勇,张亮.大型双吸离心泵径向力数值模拟[J].中国农村水利水电,2009(4):57-59. Zhao Wanyong, Zhang Liang. The radial force numerical simulation for the large double suction centrifugal pump[J]. China Rural Water and Hydropower, 2009(4):57-59.(in Chinese)[3]祝磊,袁寿其,袁建平.阶梯隔舌对离心泵压力脉动和径向力影响的数值模拟[J].农业机械学报,2010,41(S1): 21-26. Zhu Lei,Yuan Shouqi,Yuan Jianping.Numerical simulation on pressure fluctuations and radial hydraulic forces in centrifugal pump with step tongue[J]. Transactions of the Chinese Society for Agricultural Machinery,2010,41(S1): 21-26.(in Chinese)[4]袁寿其,周建佳,袁建平,等.分流叶片对螺旋离心泵径向力的影响[J].农业机械学报,2012,43(3): 37-42. Yuan Shouqi,Zhou Jianjia,Yuan Jianping,et al.Numerical simulation on radial hydraulic forces for screw-type centrifugal pump with splitter blade[J]. Transactions of the Chinese Society for Agricultural Machinery,2012,43(3):37-42.(in Chinese).[5]Barrio R,Parrondo J,Blanco E. Numerical analysis of the unsteady flow in the near-tongue region in a volute-type centrifugal pump for different operation points [J]. Computers & Fluids,2010,39(5):859-870.[6]Gonzlez J,Parrondo J L, Santolari A C, et al. Steady and unsteady radial forces for a centrifugal pump with impeller to tongue gap variation [J]. Journal of Fluids Engineering, 2006,128(3):454-462.[7]Gonzlez J,Femndez J, Blanco E, et al. Numerical simulation of the dynamic effects due to impeller-volute interaction in a centrifugal pump [J]. Journal of Fluids Engineering,2002,124(2):348-355.[8]刘厚林,刘明明,白羽,等.基GCI的离心泵网络的收敛性[J].江苏大学学报:自然科学版,2014,35(3):279-283. Liu Houlin,Liu Mingming,Bai Yu,et al.Grid convergence based on GCI for centrifugal pump[J].Journal of Jiangsu University:Natural Science Edition,2014,35(3):279-283.(in Chinese)[9]周玉林.偏离工况下离心泵的压力脉动和振动分析[J].流体机械,2015,43(2):52-57. Zhou Linyu.Analysis on pressure fluctuation and vibration of a centrifugal pump for off-design conditions[J].Fluid Machinery,2015,43(2):52-57.(in Chinese).[10]关醒凡. 现代泵理论与设计[M]. 北京:中国宇航出版社, 2011.
