Numerical calculation of influence of gap between impeller shroud and diffuser side wall on performance of reactor coolant pump
CHENG Xiaorui1,2, BAO Wenrui1
1.College of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou, Gansu 730050, China; 2.Key Laboratory of Fluid Machinery and Systems, Gansu Province, Lanzhou, Gansu 730050, China
Abstract:The numerical simulations of flow of water in AP1000 reactor coolant pump model are performed based on the Reynolds averaged N-S equations and RNG k-ε turbulence model by using SIMPLE algorithm. Firstly, the size of the gap between the impeller shroud and the diffuser side wall is designed with four values. Secondly, the flow field in the pumps with these sizes are simulated. Finally, the axial thrust and flow structures in the gap and collector are obtained and discussed under various gap sizes. The results show that the gap size has a certain impact on the pump head and efficiency in a range of 0.8Qd-1.2Qd flow rate. The change in gap size can cause a shift of best efficiency point from the design point, but the shift scale and direction do not correlate with the gap size evidently. Under the design condition, the pump efficiency at 0.6 mm gap is better than the others, and increased by 1.66% compared with 1.8mm gap. Under 1.2Qd flow condition, the pump is more efficient at 1.8 mm gap than at other gaps, and the pump efficiency is improved by 2.17% compared with 2.4 mm gap. Under all working conditions, the gap size has less influence on the axial thrust which shows a monotonic decreasing trend as the flow rate increases. The analytical axial thrust is much lower than the tested value obviously. But with increasing flow rate, the analytical axial thrust approaches the measurement.
程效锐,, 包文瑞. 核主泵前腔间隙对性能影响的数值计算[J]. 排灌机械工程学报, 2016, 34(9): 748-754.
CHENG Xiaorui,, BAO Wenrui. Numerical calculation of influence of gap between impeller shroud and diffuser side wall on performance of reactor coolant pump. Journal of Drainage and Irrigation Machinery Engin, 2016, 34(9): 748-754.
[1]宫晓清,孟祥铠,李纪云,等. 核主泵用流体动压型机械密封温度场的数值研究[J].流体机械, 2015, 43(7):16-21.GONG Xiaoqing,MENG Xiangkai,LI Jiyun,et al.Numerical research on temperature of hydrodynamic mechanical seals in reactor coolant pump[J]. Fluid machinery, 2015, 43(7):16-21.(in Chinese)[2]KAZAKOV Y A,PELINSKII A A.Experimental investigation of the axial force in a submersible electric well pump[J]. Chemical and petroleum engineering, 1970,6(3):262-263.[3]马旭丹,吴大转,王乐勤.多级离心泵轴向力平衡装置的设计与分析[J].农业工程学报,2010,26(8):108-112. MA Xudan, WU Dazhuan, WANG Leqin. Design and analysis of an axial thrust balancing device for multistage centrifugal pumps[J]. Transactions of the CSAE, 2010, 26(8): 108-112.(in Chinese)[4]CALUM S. Considerations for a canned motor pump[J].World pumps, 2004(12): 22-25.[5]李伟,施卫东,蒋小平,等.屏蔽泵轴向力平衡新方法[J].农业工程学报,2012,28(7):86-90. LI Wei, SHI Weidong, JIANG Xiaoping, et al. New method for axial force balance of canned motor pump[J]. Transactions of the CSAE, 2012, 28(7): 86-90.(in Chinese)[6]周哲波,李明,杨小娇,等.叶轮对称布置式多级泵轴向力平衡研究[J].煤矿机械,2015,36(9):107-108.ZHOU Zhebo,LI Ming,YANG Xiaojiao,et al. Study on balance axial force of symmetrical arrangement of impeller multistage pump[J]. Coal mine machinery, 2015,36(9):107-108.(in Chinese)[7]BARRIO R, PARRONDO J, BLANCO E. Numerical analysis of the unsteady flow in the near-tongue region in a volute-type centrifugal pump for different operating points[J]. Computers & fluids, 2010,39:859-870.[8]王福军.计算流体动力学分析——CFD软件原理与应用[M]. 北京:清华大学出版社,2004.[9]王秀勇,王灿星,黎义斌.离心泵腔中流动特性的数值分析[J].农业机械学报,2009,40(4):86-90. WANG Xiuyong, WANG Canxing, LI Yibin. Numerical study of flow characteristics in the impeller side chamber of centrifugal pump[J]. Transactions of the CSAM, 2009,40(4):75-80.(in Chinese)[10]关醒凡.现代泵理论与设计[M].北京:中国宇航出版社,2011.[11]曹卫东,代珣,胡啟祥,等. 矿用抢险多级泵转子部件轴向力数值模拟及平衡方法研究[J]. 流体机械, 2014,42(6):16-20. CAO Weidong, DAI Xun, HU Qixiang,et al. Numerical simulation and balance method research for axial force of rotation components on mine emergency multi-stage pump [J]. Fluid machinery, 2012,42(6):16-20.(in Chinese)[12]朱荣生,郑宝义,袁寿其,等.1 000 MW核主泵失水事故工况下气液两相流分析[J].原子能科学技术,2012,46(10):1202-1206. ZHU Rongsheng, ZHENG Baoyi, YUAN Shouqi, et al. 1 000 MW nuclear main pump gas-liquid two-phase flow analysis under loss of coolant accident[J]. Atomic energy science and technology, 2012,46(10): 1202-1206.(in Chinese)