Abstract:In order to study the influence of tongue angles on hydraulic and structural performances of double channel pump, three cases with different tongue angles were simulated by the two-way coupling fluid-structure interaction(FSI)method. The result shows that in the hydraulic performance aspect, the influence of tongue angles on flow-head is weak, and the maximum difference is 0.09 m,but the maximum difference of efficiency is 1.1%. Tongue angle mainly affects the pressure fluctuation in and after the tongue edge,and the larger the tongue angle is,the stronger the fluctuation is.Because of the asymmetry of the volute, radial force on the volute is very large.It is periodical when the impeller rotates one circle and decreases obviously with the increasing of the tongue angle. In the structural performance aspect,stress concentration of the impeller appears in the suction surface near the outlet,and the volute stress concentration appears near the tongue edge.The increasing of tongue angle will increase the value of the maximum stress of the impeller and volute,but the amplitude will decrease. Displacement with the magnitude 10-5 m happens in the pump, and the maximum displacement appears at the outlet of the volute. It is periodical and is mainly influenced by the blade-passing frequency. The tongue angle has little impact on the maximum displacement,but has an obvious effect on the vibration velocity of the pump.Larger tongue angle can suppress the vibration.
[1]VAN ESCH B P M,KRUYT N P.Hydraulic performance of a mixed-flow pump: unsteady inviscid computations and loss models[J].ASME journal of fluids engineering,2001,123(2):256-264.[2]ORO J M F, GARCIA B P, GONZALEZ J, et al. Numerical methodology for the assessment of relative and absolute deterministic flow structures in the analysis of impeller-tongue interactions for centrifugal fans [J]. Computers & fluids, 2013, 86(7):310-325.[3]BARRIO R, PARRONDO J, BLANCO E. Numerical analysis of the unsteady flow in the near-tongue region in a volute-type centrifugal pump for different operating points[J]. Computers and fluids,2010,39(5):859-870.[4]BENRA F K. Numerical and experimental investigation on the flow induced oscillations of a single-blade pump impeller[J].ASME journal of fluids engineering,2006,128(4):783-793.[5]施卫东, 徐焰栋, 李伟, 等. 蜗壳隔舌安放角对离心泵内部非定常流场的影响[J]. 农业机械学报,2013,44(S1):125-130. SHI Weidong, XU Yandong, LI Wei, et al. Effect of different tongue angels on unsteady flow in centrifugal pump [J]. Transactions of the CSAM,2013, 44(S1):125-130.(in Chinese)[6]ZHANG Jianping, GUO Liang, WU Helen, et al. The influence of wind shear on vibration of geometrically nonlinear wind turbine blade under fluid-structure interaction[J]. Ocean engineering, 2014, 84(4):14-19.[7]胡丹梅, 张志超, 孙凯, 等. 风力机叶片流固耦合计算分析[J]. 中国电机工程学报,2013,33(17):98-104. HU Danmei, ZHANG Zhichao,SUN Kai,et al. Computational analysis of wind turbine blades based on fluid-structure interaction[J].Proceedings of the CSEE, 2013,33(17):98-104.(in Chinese)[8]WANG Zheng, WANG Zengquan, ZHUANG Li, et al. Time-dependent vibration frequency reliability analysis of blade vibration of compressor wheel of turbocharger for vehicle application[J]. Chinese journal of mechanical engineering, 2014, 27(1):205-210.[9]FRIEDRICH-KARL B, HANS J D. Comparison of pump impeller orbit curves obtained by measurement and FSI simulation[C]//Proceedings of the 2007 ASME Pressure Vessels and Piping Conference, San Antonio, TX, USA, 2007:41-48.[10]黄思,张雪娇,宿向辉,等. 基于离心泵全流场的流固耦合分析[J]. 流体机械, 2015, 43(11):38-42. HUANG Si,ZHANG Xuejiao,SU Xianghui, et al. Fluid-solid interaction analysis of centrifugal pump based on whole flow field[J]. Fluid machinery, 2015, 43(11):38-42.(in Chinese)[11]查海滨,姜营,王君,等. 涡旋压缩机单向流固耦合方法与涡旋齿变形分析[J]. 流体机械, 2015, 43(12):22-27. ZHA Haibin, JIANG Ying,WANG Jun, et al. One-way fluid-structure interaction method of scroll compressor and analysis on the deformation of the wrap[J]. Fluid machinery, 2015, 43(12):22-27.(in Chinese)[12]JIN W K, YANG S K, CHI Y P. Failure analysis of cracking at volute tongues of feedwater pump casings[J]. Engineering failure analysis, 2002, 9(1):17-30.[13]赵斌娟,侯多华,陈汇龙,等. 隔舌间隙对双流道泵瞬态流动特性的影响[J]. 中国农村水利水电,2014(5):118-123. ZHAO Binjuan,HOU Duohua,CHEN Huilong,et al.The influence of volute tongue-impeller gaps on the unsteady performance in double-channel pumps[J]. China rural water and hydropower, 2014(5):118-123.(in Chinese)[14]赵斌娟,王瑜,陈汇龙,等. 离心泵尾流-射流现象及粗糙度对其影响的分析[J]. 农业机械学报, 2014, 45(9):138-143. ZHAO Binjuan,WANG Yu,CHEN Huilong,et al. Jet-wake flow in the channel of impeller and the effect of surface roughness on it[J]. Transactions of the CSAM, 2014, 45(9):138-143.(in Chinese)[15]赵斌娟,侯多华,陈汇龙,等. 叶轮流道结构对双流道泵性能的影响[J]. 排灌机械工程学报,2013, 31(4):294-299. ZHAO Binjuan, HOU Duohua, CHEN Huilong, et al. Influence of impeller passage structure on performance of double-channel pumps [J]. Journal of drainage and irrigation machinery engineering, 2013, 31(4):294-299.(in Chinese)[16]刘厚林,徐欢,吴贤芳,等. 流固耦合作用对离心泵内外特性的影响[J]. 农业工程学报,2012,28(13):82-87. LIU Houlin, XU Huan, WU Xianfang, et al. Effect of fluid-structure interaction on internal and external characteristics of centrifugal pump[J]. Transactions of the CSAE, 2012, 28(13):82-87.(in Chinese)[17]张德胜,张磊,施卫东,等. 基于流固耦合的离心泵蜗壳振动特性优化[J]. 农业机械学报,2013,44(9):40-45. ZHANG Desheng, ZHANG Lei, SHI Weidong,et al.Optimization of vibration characteristics for centrifugal pump volute based on fluid-structure interaction[J]. Transactions of the CSAM,2013,44(9):40-45.(in Chinese)