Application of CFD technology in air-assisted spraying in orchard and analysis of its prospects
Zhou Liangfu1, Xue Xinyu1, Jia Weidong2, Ding Suming1, Sun Zhu1
1.Nanjing Research Institute for Agricultural Mechanization, Ministry of Agriculture, Nanjing, Jiangsu 210014, China; 2.Institute of Agricultural Engineering, Jiangsu University, Zhenjiang, Jiangsu 212013, China
Abstract:With the rapid development of numerical computational theory and computer technology, CFD technology has been extensively used in agricultural engineering to vividly visualize flows. This review mainly focused on applications of CFD technology in structure optimization(number of blades, backflow structure, stress in blade, blade angle and duct configuration)and performance prediction(efficiency and noise)of fans in air-assisted sprayer as well as validation of standard k-ε turbulence model. Additionally, the feasibility of Lagrangian method for handling interaction between air and disperse phase is verified by applying CFD technology to identify microscopic characteristics of spray. Unfortunately, CFD technology cannot provide any information about atomization mechanism of spray pre-sently. The standard k-ε turbulence model has been applied and verified in internal flow and droplet deposition on canopy. However, the effects of canopy on turbulent kinetic energy dissipation are not explored in detail, and there is lack of study on droplet deposition model. Finally, a few prospects for structure optimization and performance prediction of fans, atomization mechanism and effects of canopy on spraying flow are highlighted. Furthermore, it is proposed that how to determine the spray capacity and velocity which can match a specific canopy should be the hotpot problem in future.
周良富, 薛新宇, 贾卫东, 丁素明, 孙竹. CFD技术在果树风送喷雾中的应用与前景分析[J]. 排灌机械工程学报, 2014, 32(9): 776-782.
Zhou Liangfu, Xue Xinyu, Jia Weidong, Ding Suming, Sun Zhu. Application of CFD technology in air-assisted spraying in orchard and analysis of its prospects. Journal of Drainage and Irrigation Machinery Engin, 2014, 32(9): 776-782.
[1]屠豫钦,李秉礼.农药应用工艺学导论[M].北京:化学工业出版社,2006:360-367.[2]傅锡敏, 吕晓兰, 丁为民, 等. 我国果园植保机械现状与技术需求[J]. 中国农机化, 2009(6): 10-13, 17. Fu Ximin, Lü Xiaolan,Ding Weimin,et al. Present state and technical requirement about orchard plant protection machinery in China[J]. Chinese Agricultural Mechanization, 2009(6): 10-13, 17.(in Chinese)[3]王福军.计算流体动力学分析——CFD软件原理与应用[M].北京:清华大学出版社,2004.[4]伍先俊,朱石坚.轴流通风机叶片模态仿真及其对气动噪声的影响[J].风机技术,2004(5):40-43. Wu Xianjun,Zhu Shijian. Modal simulation of axial fan blade and the effect of that on aerodynamic noise[J]. Compressor Blower & Fan Technology,2004(5):40-43.(in Chinese)[5]Zhang Lixian. Fluent-based numerical simulation of flow centrifugal fan[J]. Journal of Coal Science & Enginee-ring, 2011, 17(2): 198-200.[6]Takaaki H, Nobuhiko Y,Tsutomu O. Numerical simulation for fan broadband noise prediction[J].Journal of Thermal Science,2011, 20(1): 58-63.[7]李亮,王瑞,金晗辉. 基于非线性湍流模型的多翼离心风机内部流场三维数值模拟及性能预测[J].流体机械,2012, 40(10):41-45. Li Liang, Wang Rui, Jin Hanhui. Three dimensional numerical simulation of internal flow field in multiblade centrifugal fan ased on the non-linear turbulent model[J]. Fluid Machinery,2012,40(10): 41-45.(in Chinese)[8]张兆鑫,赵元虎,徐奔驰. 基于CFD法的小型风机非扭曲叶片气动性能分析[J]. 浙江工业大学学报,2013,41(1):68-72. Zhang Zhaoxin,Zhao Yuanhu,Xu Benchi. Aerodynamic performance analysis of untwisted blade for small wind turbine based CFD method[J]. Journal of Zhejiang University of Technology,2013,41(1):68-72.(in Chinese)[9]Endalew A M,Debaerb C,Rutten N, et al. A new integrated CFD modelling approach towards air-assisted orchard spraying—Part I: Model development and effect of wind speed and direction on sprayer airflow[J]. Computers and Electronics in Agriculture,2010, 71(1):128-136.[10]祁力钧, 王虎, 张建华,等. 温室轨道式弥雾机气流速度场三维模拟与试验[J].农业机械学报,2013,44(2): 69-74. Qi Lijun,Wang Hu,Zhang Jianhua,et al. 3-D numerical simulation and experiment of air-velocity distribution of greenhouse air-assisted sprayer[J]. Transactions of the Chinese Society for Agricultural Machinery, 2013,44(2): 69-74.(in Chinese)[11]周良富,张晓辛,吕晓兰,等. 圆盘雾化器风力性能数值分析与试验[J].农业机械学报,2012, 43(10):72-75. Zhou Liangfu, Zhang Xiaoxin,Lü Xiaolan,et al. Numeri-cal simulation and exerimental study on the wind performance of the disc atomizer[J].Transactions of the Chinese Society for Agricultural Machinery, 2012,43(10):72-75.(in Chinese)[12]傅泽田,王俊,祁力钧,等. 果园风送式喷雾机气流速度场模拟及试验验证[J]. 农业工程学报,2009,25(1):69-74. Fu Zetian,Wang Jun,Qi Lijun,et al.CFD simulation and experimental verification of air-velocity distribution of air-assisted orchard sprayer[J].Transactions of the CSAE,2009,25(1):69-74.(in Chinese)[13]Chen Shiqiang, Wang Haiqiao, Cheng Jianlin,et al. Numerical simulation investigations of energy-saving diffuser of main fan [J]. Journal of Coal Science & Engineering, 2010, 16(4): 424-428.[14]Wang Haiqiao, Zou Zuyun,Chen Shiqiang, et al. Numerical simulation investigation on pressure loss of diffusion tank of axial main fan[J]. Journal of Coal Science & Engineering, 2011, 17(4): 447-449.[15]宋淑然,夏侯炳,卢玉华,等.风送式喷雾机导流器结构优化及试验研究[J].农业工程学报,2012,28(6):7-12. Song Shuran, Xia Houbing, Lu Yuhua, et al. Structural optimization and experiment on fluid director of air-assisted sprayer[J].Transactions of the CSAE, 2012, 28(6): 7-12.(in Chinese)[16]李晟.基于Fluent软件的轴流风机设计初步研究[D].西安:西北工业大学动力与能源学院,2004.[17]庞佑霞,唐勇,梁亮,等. 贯流风机结构参数优化组合研究[J]. 农业机械学报,2011,42(9):102-107. Pang Youxia, Tang Yong, Liang Liang, et al. Optimum combination of structure parameters of cross flow fans[J]. Transactions of the Chinese Society for Agricultural Machinery,2011,42(9):102-107.(in Chinese)[18]吴卫东,刘春生,高兴海.进口节流调节对风机噪声测试影响的数值模拟[J].黑龙江科技大学学报,2003,13(1):7-10,14. Wu Weidong,Liu Chunsheng,Gao Xinghai. Numerical simulation of influence to fan s noise testing with entrance throttling governing[J].Journal of Heilongjiang Institute of Science & Technology, 2003, 13(1):7-10,14.(in Chinese)[19]娄小军.变频控制的地铁变风量控制方案研究[D].天津:天津大学环境科学与工程学院,2002.[20]文华. 基于CFD的柴油机喷雾混合过程的多维数值模拟[D].武汉:华中科技大学能源与动力工程学院,2004.[21]Merouane A H,Abidat B M. Numerical simulation of a turbulent flow with droplets injection in annular heated air tube using the Reynolds stress model[J].Heat Mass Transfer,2013,49:1711-1723.[22]Badock C, Wirth R,Fath A,et al. Investigation of cavitation in real size diesel injection nozzle[J].Internatio-nal Journal of Heat and Fluid Flow, 1999,20:538-544.[23]Turnera M R, Sazhina S S, Healey J J,et al. A breakup model for transient Diesel fuel sprays[J]. Fuel,2012,97:288-305. [24]Opfer L, Roisman I V, Tropea C. Primary atomization in an airblast gas turbine atomizer[J]. Fluid Mechanics and Its Applications, 2013, 1581:3-27.[25]Desantes J M, Payri R, Salvador F J, et al. Influence of cavitation phenomenon on primary break-up and spray behavior at stationary conditions[J]. Fuel,2010,89: 3033-3041. [26]Som S, Aggarwal S K. Effects of primary breakup mode-ling on spray and combustion characteristics of compression ignition engines[J]. Combustion and Flame, 2010,157(6):1179-1193.[27]Mohan B, Yang W, Chou S K. Development of an accurate cavitation coupled spray model for diesel engine simulation[J]. Energy Conversion and Management, 2014,77:269-277.[28]Karimi Mo, Jodoin Bertrand, Rankin Gary. Shock-wave-induced spraying: Modeling and physics of a new spray process[J]. Journal of Thermal Spray Technology,2011,20(4):866-881.[29]Sova A, Okunkova A, Grig S,et al. Velocity of the particles accelerated by a cold spray micronozzle: Experimental measurements and numerical simulation[J].Journal of Thermal Spray Technology,2013,22(1):75-80.[30]Tao Yujia, Huai Xiulan, Guo Ziyi,et al. Numerical simulation of spray performance based on the Euler-Lagrange approach[J]. Journal of Thermal Science,2009,18(1):91-96.[31]Zeoli N,Tabbara H,Gu S. Three-dimensional simulation of primary break-up in a close-coupled atomizer[J].Applied Physics A:Materials Science & Processing,2012,108:783-792.[32]Lopes A S, Palma J M L M, Lopes J V. Improving a two-equation turbulence model for canopy flows using large-eddy simulation[J]. Boundary-Layer Meteorology,2013,149(2):231-257.[33]Schlegel F, Stiller J, Bienert A,et al. Large-eddy simulation of inhomogeneous canopy flows using high resolution terrestrial laser scanning data[J].Boundary-Layer Meteorology,2012,142(2):223-243.[34]Bohrer G, Katul G G Walko R L, et al. Exploring the effects of microscale structural heterogeneity of forest canopies using large-eddy simulations [J].Boundary-Layer Meteorology,2009,132(3):351-382.[35]Mockett C, Perrin R, Reimann T, et al. Analysis of detached-eddy simulation for the flow around a circular cylinder with reference to PIV data [J]. Flow Turbulence Combust,2010,85(2):167-180.[36]Katul G G, Mahrt L,Poggi D,et al. One-and two-equation models for canopy turbulence[J]. Boundary-Layer Meteorology,2004,113(1):81-109.[37]Farooq M, Salyani M. Modeling of spray penetration and deposition on citrus tree canopies[J]. Transactions of the ASAE,2004,47(3):619-627.[38]Endalew A M, Debaer C,Rutten N,et al. Modelling the effect of tree foliage on sprayer airflow in orchards[J]. Boundary-Layer Meteorology,2011,138(1): 139-162.[39]Endalew A M, Debaer C,Rutten N, et al. A new integrated CFD modelling approach towards air-assisted orchard spraying—Part II: Validation for different sprayer types[J].Computers and Electronics in Agriculture,2010, 71(1):137-147.[40]Rosenfeld M, Marom G, Bitan A. Numerical simulation of the airflow across trees in a windbreak[J]. Boundary-Layer Meteorology,2010,135(1):89-107.[41]Bailey B N, Stoll R. Turbulence in sparse, organized vegetative canopies: A large-eddy simulation study[J].Boundary-Layer Meteorology,2013,147(3):369-400.