Effect of wear-ring clearance on performance and flow characteristics of centrifugal pump
GAO Bo1, WANG Zhen1, YANG Li1, DU Wenqiang1, LI Changjun2
1.School of Energy and Power Engineering, Jiangsu University, Zhenjiang, Jiangsu 212013, China; 2.CNNC China Zhongyuan Engineering Corp, Shanghai 200233, China
Abstract:In order to explore the influence of different wear-ring sizes on the performance and flow characteristic in a centrifugal pump, both numerical simulation and performance test are conducted in a centrifugal model pump. Two normal wear-ring clearances(0.25 mm and 0.50 mm)and an abnormal big gap(0.75 mm)are selected. By comparing the pump performance and flow characteristics at every clearance, the influence of wear-ring size on the performance and flow is obtained. It is shown that with increasing clearance both the pump head and the efficiency decrease. The radial thrust on the impeller reaches the largest at 0.50 mm gap, decreases at 0.25 mm, and eventually arrives at the smallest thrust at 0.75 mm. The total pressure is distributed more evenly in the axial cross-section of the wear-ring at a larger clearance. The total pressure near the side chamber decreases, but that near the impeller eye increases. Because of being affected by the centrifugal force on the shroud, the radial velocity magnitude and vorticity of the fluid in the chamber between the shroud and the casing increase gradually with increasing clearance, causing an even more smooth streamline pattern there.
高波, 王震, 杨丽, 杜文强, 李长军. 叶轮口环间隙对离心泵性能及流动特性的影响[J]. 排灌机械工程学报, 2017, 35(1): 13-17.
GAO Bo, WANG Zhen, YANG Li, DU Wenqiang, LI Changjun. Effect of wear-ring clearance on performance and flow characteristics of centrifugal pump. Journal of Drainage and Irrigation Machinery Engin, 2017, 35(1): 13-17.
[1]陈鱼,费振桃,蔡永雄,等.输送清水时口环间隙对离心油泵性能的影响[J].流体机械,2006,34(1)1-5. CHEN Yu, FEI Zhentao, CAI Yongxiong, et al. Effect of the clearance of wear-rings on the performance of centrifugal oil pump while handling water [J]. Fluid machinery,2006, 34(1):1-5.(in Chinese)[2]赵伟国,邬国秀,黎义斌,等. 口环间隙变化对离心泵性能的影响研究[J].水力发电学报,2014 33(5):211-215. ZHAO Weiguo, WU Guoxiu, LI Yibin, et al. Study on effects of wear-rings clearance modifications on performance of centrifugal pump[J]. Journal of hydroelectric engineering, 2014, 33(5):211-215.(in Chinese)[3]潘中永,陈士星,张大庆,等.叶轮口环间隙对离心泵性能影响的模拟和试验[J]. 流体机械,2012 40(12):10-14. PAN Zhongyong,CHEN Shixing,ZHANG Daqing. Simulation and experiment of the effect of clearance of impeller wearrings on the performance of centrifugal pump[J]. Fluid machinery,2012,40(12):10-14.(in Chinese)[4]李文广,费振桃,蔡永雄.离心油泵叶轮口环间隙对性能的影响[J].水泵技术,2004(5):7-13. LI Wenguang, FEI Zhentao, CAI Yongxiong. Effect of the clearance of wear-rings on the performance of centrifugal oil pump [J]. Pump technology, 2004(5): 7-13.(in Chinese)[5]王洋,张翔.叶轮口环间隙对低比转速离心泵效率的影响[J].排灌机械, 2008,26(6):27-30. WANG Yang, ZHANG Xiang. Effect of clearance of impeller wear-rings on efficiency of low specific speed centrifugal pump [J]. Drainage and irrigation machinery, 2008, 26(6): 27-30.(in Chinese)[6]ZHANG Desheng, SHI Weidong, van Esch B P M, et al. Numerical and experimental investigation of tip leakage vortex trajectory and dynamics in an axial flow pump[J]. Computers & fluids, 2015,112:61-71.[7]YOU D, WANG M, MOIN P, et al. Vortex dynamics and low-pressure fluctuations in the tip-clearance flow[J]. Journal of fluids engineering, 2007, 129(8): 1002-1014.[8]赵万勇,赵爽,王磊,等.离心油泵口环间隙对泵腔内流动的影响[J].兰州理工大学学报, 2013, 39(1): 33-36. ZHAO Wanyong, ZHAO Shuang, WANG Lei, et al. Influence of seal ring clearance of centrifugal oil pump on flow characteristics of pump chamber[J]. Journal of Lanzhou University of Technology, 2013, 39(1): 33-36.(in Chinese)[9]张金凤,梁赟,袁建平,等.离心泵进口回流流场及其控制方法的数值模拟[J].江苏大学学报(自然科学版), 2012, 33(4):402-407. ZHANG Jinfeng, LIANG Yun, YUAN Jianping, et al. Numerical simulation of recirculation control at centrifugal pump inlet [J]. Journal of Jiangsu University(natural science edition),2012, 33(4):402-407.(in Chinese)[10]BASKHARONE E J. Primary/leakage flow interaction in a pump stage [J]. Journal of fluids engineering, 1999,121(3): 133-138.[11]严俊峰,陈炜,蒲光荣.叶轮盖板侧的流动对离心泵泄漏量的影响[J].火箭推进,2007,33(3):20-25. YAN Junfeng, CHEN Wei, PU Guangrong. The effect of flow in impeller cover on leakage flow in a centrifugal pump[J]. Rocket propulsion,2007,33(3):20-25.(in Chinese)[12]ZHAO W G, LI Y B,WANG X Y. Research on the effect of wear-ring clearances to the performance of centrifugal pump[C]//Proceedings of the 26th IAHR Symposium on Hydraulic Machinery and Systems, 2012.[13]ADKINS D R, BRENNEN C E. Analysis of hydrodynamic radial forces on centrifugal pump impellers[J]. Journal of fluids engineering,1988, 110(1): 20-28.