Influence of asymmetric thermal resistance on performance of thermoelectric generator
1. School of Automotive and Traffic Engineering, Jiangsu University, Zhenjiang, Jiangsu 212013, China； 2. Department of Energy Technology, Aalborg University, Aalborg, Nordjylland 9220, Denmark
Abstract：To optimize the thermal resistance of thermoelectric generator for improving performance, the output performance variation of thermoelectric generator with different thermal resistance at both sides was investigated. The external ceramic substrates with different thermal conductivity and thickness were used to simulate the thermal resistance at both sides of thermoelectric generator. The variation of temperature difference, open-circuit voltage, output power and maximum output power of thermoelectric generator at different hot source temperatures and load resistances was analyzed. The results show that when the thermal resistance at both sides of the thermoelectric generator is the same, the temperature difference and the open-circuit voltage are increased with the increasing of hot source temperature. When the thermal resistance at both sides of thermoelectric generator is different, the open-circuit voltage and the maximum output power are increased with the increasing of hot source temperature. The effective temperature difference is increased with the increasing of load resistance, and the power is increased first with latter decreasing when the load resistance is increased. Compared to the performance of thermoelectric generator with the same thermal resistance at both sides, the ceramic substrate with smaller thermal resistance at the hot side is more beneficial to improve the output performance of thermoelectric generator, and the improvement effect is more obvious near the maximum power point. The open-circuit voltage, the maximum output power and the maximum effective temperature difference can be increased by 0.64 V, 0.87 W and 24.5 ℃, respectively.
ZHENG X F, LIU C X, YAN Y Y, et al. A review of thermoelectrics research: recent developments and potentials for sustainable and renewable energy applications[J]. Renewable and Sustainable Energy Reviews, 2014, 32: 486-503.
［2］
WANG C L, TANG S M, LIU X, et al. Experimental study on heat pipe thermoelectric generator for industrial high temperature waste heat recovery[J]. Applied Thermal Engineering, doi: 10.1016/j.applthermaleng.2020.115299.
［3］
LI G N, ZHANG S, ZHENG Y Q, et al. Experimental study on a stove-powered thermoelectric generator (STEG) with self starting fan cooling[J]. Renewable Energy, 2018, 121: 502-512.
［4］
NADER W B. Thermoelectric generator optimization for hybrid electric vehicles[J]. Applied Thermal Enginee-ring, doi: 10.1016/j.applthermaleng.2019.114761.
ZHOU G L, WU J, WANG M Y. Experimental study of series and parallel waste heat recovery modes for electric vehicle heat pump system[J]. Fluid Machinery, 2021, 49(5):91-96. (in Chinese)
［6］
MASSAGUER A, PUJOL T, COMAMALA M, et al. Feasibility study on a vehicular thermoelectric generator coupled to an exhaust gas heater to improve aftertreatment′s efficiency in cold-starts[J]. Applied Thermal Engineering, doi: 10.1016/j.applthermaleng.2019.114702.
［7］
LAN S, SMITH A, STOBART R, et al. Feasibility study on a vehicular thermoelectric generator for both waste heat recovery and engine oil warm-up[J]. Applied Energy, 2019, 242: 273-284.
［8］
LI G N, ZHENG Y Q, HU J G, et al. Experiments and a simplified theoretical model for a water-cooled, stove-powered thermoelectric generator[J]. Energy, 2019, 185: 437-448.
［9］
WANG S X, XIE T X, XIE H X. Experimental study of the effects of the thermal contact resistance on the performance of thermoelectric generator[J]. Applied Thermal Engineering, 2018, 130: 847-853.
[10]
LIAO M J, HE Z, JIANG C P, et al. A three-dimensional model for thermoelectric generator and the in-fluence of Peltier effect on the performance and heat transfer[J]. Applied Thermal Engineering, 2018, 133: 493-500.
[11]
FAN S F, GAO Y W. Numerical simulation on thermoelectric and mechanical performance of annular thermoelectric generator[J]. Energy, 2018, 150: 38-48.
[12]
KARANA D R, SAHOO R R. Influence of geometric parameter on the performance of a new asymmetrical and segmented thermoelectric generator[J]. Energy, 2019, 179: 90-99.
2023, Vol. 44 
