基于Fluent的四氟乙烯爆炸数值模拟

刘宏, 薛苗苗, 陈明毅, 孔庆红, 赵路遥, 李晨琛

江苏大学学报(自然科学版) ›› 2022, Vol. 43 ›› Issue (6) : 732-736.

PDF(2631 KB)
全国中文核心期刊
中国科技核心期刊
RCCES核心期刊
SCD核心期刊
PDF(2631 KB)
江苏大学学报(自然科学版) ›› 2022, Vol. 43 ›› Issue (6) : 732-736. DOI: 10.3969/j.issn.1671-7775.2022.06.017
论文

基于Fluent的四氟乙烯爆炸数值模拟

作者信息 +

Numerical simulation of tetrafluoroethylene explosion based on Fluent

Author information +
文章历史 +

摘要

通过Fluent软件建立了四氟乙烯爆炸模型,数值模拟了直径为70 mm、高度为500 mm的圆柱形反应器内四氟乙烯的爆炸状况,分析了反应器内四氟乙烯爆炸时的温度和压力变化规律,并揭示了四氟乙烯爆炸火焰与压力波的特性.模拟结果表明:在四氟乙烯点火发生后20 ms内,反应器内监控点的压力与温度升高速度均较快,之后压力和温度数值平缓升高,温度最大值为2 000 K,压力最大值为608.000 kPa;数值模拟结果与文献中的试验结果吻合较好,验证了所建立的四氟乙烯爆炸模型具有一定的可靠性.研究结果可为氟化工四氟乙烯爆炸后果预测提供技术指导.

Abstract

The tetrafluoroethylene explosion model was established by Fluent software, and the tetrafluoroethylene explosion in a cylindrical reactor with diameter of 70 mm and height of 500 mm was numerically simulated. The changes of temperature and pressure in the reactor were analyzed, and the flame and pressure wave characteristics of the explosion field were revealed. The results show that within 20 ms after the ignition of tetrafluoroethylene, the pressure and temperature of the monitoring point in the reactor rise rapidly, and then the values rise gently with the maximum temperature of 2 000 K and the maximum pressure of 608.000 kPa. The simulation results are consistent with the experimental results in the literature, which can verify the reliability of the tetrafluoroethylene explosion model. The research results can provide technical support for predicting the consequences of fluorine chemical tetrafluoroethylene explosion.

关键词

四氟乙烯 / 爆炸 / 压力 / 温度 / 数值模拟

Key words

tetrafluoroethylene / explosion / pressure / temperature / numerical simulation

引用本文

导出引用
刘宏, 薛苗苗, 陈明毅, . 基于Fluent的四氟乙烯爆炸数值模拟[J]. 江苏大学学报(自然科学版), 2022, 43(6): 732-736 https://doi.org/10.3969/j.issn.1671-7775.2022.06.017
LIU Hong, XUE Miaomiao, CHEN Mingyi, et al. Numerical simulation of tetrafluoroethylene explosion based on Fluent[J]. Journal of Jiangsu University(Natural Science Edition), 2022, 43(6): 732-736 https://doi.org/10.3969/j.issn.1671-7775.2022.06.017

参考文献

[1]潘炎刚.聚四氟乙烯安全生产常识[J].含氟材料, 1988 (3):29-34.
PAN Y G.Common sense of safe production of PTFE[J].Fluorine-containing Materials, 1988 (3):29-34.(in Chinese)
[2]张士林.聚四氟乙烯安全生产技术浅谈[C]∥中国氟化工生产技术交流会论文集.上海:中国氟硅有机材料工业协会有机氟专业委员会,2009:127-130.
[3]曹钧.聚四氟乙烯生产过程重大风险研究[J]. 安全、健康和环境, 2017, 17(6):40-43.
CAO J.Study on the significant risk of teflon production[J].Safety, Health and Environment, 2017,17 (6):40-43.(in Chinese)
[4]贾国栋.蒙德法对四氟乙烯生产工艺装置的安全分析[J]. 产业与科技论坛, 2013,12(24):82-83,10.
JIA G D.The safety analysis of the Mond method to the tetrafluoroethylene production process equipment[J].Industrial & Science Tribune, 2013,12(24):82-83,10.(in Chinese)
[5]刘宏, 李晨琛, 陈明毅,等.基于ALOHA的四氟乙烯计量槽爆炸后果分析[J]. 消防科学与技术, 2021, 40(1): 20-24.
LIU H, LI C C, CHEN M Y, et al. Explosion analysis of the tetrafluoroethylene metering tank based on ALOHA[J]. Fire Science and Technology, 2021, 40(1): 20-24.(in Chinese)
[6]FERRERO F, MEYER R, KLUGE M, et al. Selfignition of tetrafluoroethylene induced by rapid valveope-ning in small diameter pipes[J].Journal of Loss Prevention in the Process Industries, 2013, 26(1):177-185.
[7]FERRERO F, MEYER R, KLUGE M, et al.Study of the spontaneous ignition of stoichiometric tetrafluoroe-thylene-air mixtures at elevated pressures[J]. Journal of Loss Prevention in the Process Industries, 2013, 26(4):759-765.
[8]LISOCHKIN Y A, POZNYAK V I.Explosive-hazard estimates for several fluorine-containing monomers and their mixtures, based on the minimum ignition pressure with a fixed igniter energy[J].Combustion, Explosion and Shock Waves, 2006, 42(2):140-143.
[9]XIONG Y Y, MA Y W, ZHAO H P, et al. Simulation study on the explosion characteristics of premixed hydrogen-air mixtures[J]. IOP Conference Series: Earth and Environmental Science, 2020, 546:42-62.
[10]邱天,潘荣锟,顾秋月,等.不同爆炸条件下MFBL型防爆门泄压的模拟研究[J].南京工业大学学报(自然科学版),2021,43(2):177-183.
QIU T, PAN R K, GU Q Y, et al. Simulation study on pressure relieving of MFBL explosion-proof door under different explosion conditions[J]. Journal of Nanjing Tech University(Natural Science Edition),2021,43(2):177-183.(in Chinese)
[11]BIRYULIN Y S, BORISOV A A, MAILKOV A E, et al. Explosive characteristics of tetrafluoroethylene[J]. Russian Journal of Physical Chemistry B, 2014, 8(2):165-171.
[12]贾国海, 李立君, 高自成, 等.新型生物质颗粒回转燃烧器流动特性仿真分析[J].江苏大学学报(自然科学版), 2018, 39(6):653-658.
JIA G H, LI L J, GAO Z C, et al.Modeling and analysis on flow characteristics for a new type biomass pellet rotary burner[J].Journal of Jiangsu University(Natural Science Edition), 2018, 39(6):653-658.(in Chinese)
[13]王志荣, 蒋军成, 李玲.容器内可燃气体燃爆温度与压力的计算方法[J].南京工业大学学报(自然科学版), 2004, 26(1):9-12.
WANG Z R, JIANG J C,LI L.Computation methods of explosion temperature and pressure of gas explosion in vessels[J].Journal of Nanjing Tech University(Natural Science Edition), 2004, 26(1):9-12.(in Chinese)
[14]NIU Y H, SHI B M, JIANG B Y.Experimental study of overpressure evolution laws and flame propagation cha-racteristics after methane explosion in transversal pipe networks[J].Applied Thermal Engineering, 2019, 154:18-23.
[15]金凯强. 密闭管道内预混火焰传播动力学及抑制方法实验研究[D].合肥:中国科学技术大学,2019.
[16]陈长坤, 雷鹏, 史聪灵, 等.公路隧道内氢气和丙烷爆炸数值模拟对比分析[J].中国安全生产科学技术, 2017, 13(1):151-155.
CHEN C K, LEI P, SHI C L, et al.Comparative nume-rical simulation analysis on explosion of hydrogen and propane in highway tunnel[J].Journal of Safety Science and Technology, 2017, 13(1):151-155.(in Chinese)

基金

国家重点研发计划项目(2018YFC0808600)

PDF(2631 KB)

32

Accesses

0

Citation

Detail

段落导航
相关文章

/