Abstract:According to the principle of equal nozzle cross-section area, a few nozzles with different shapes were designed to study their effect on the distribution of sprinkler irrigation at low pressure. The nozzle hydraulic performances were measured, the spraying uniformity of different nozzles were analyzed by using Matlab software. Additionally, the spatial flow pattern with different nozzles were observed with high speed photographical technique. The results show that the flow rate decreases gradually with increasing nozzle cone angle at the same pressure, the flow rate through the squared cross-section nozzle is the largest, that through the triangular cross-section nozzle is the smallest. The nozzle wetted radius firstly increases then decreases with increasing cone angle, and the circular and triangular cross-section nozzles are subject to the longest and shortest wetted radius, respectively. Based on high-speed photographical images, it can be seen that the jet breaking length issued from the triangular cross-section nozzle is the shortest, while the breaking length from the circular cross-section nozzle is the longest. With increasing nozzle cone angle, three nozzle jet breaking lengths show a decreasing trend. Composting the nozzle wetted radius and the atomization effect, it can be known that the circular cross-section nozzle with 45 degrees cone angle is the best. Moreover, it is found that the combined water distribution uniformity coefficient of the non-circular cross-section nozzles is evidently better than the circular nozzle based on measurements.
周小引, 李红, 蒋跃. 低压喷头异形喷嘴水量分布均匀性试验研究[J]. 排灌机械工程学报, 2017, 35(5): 448-453.
ZHOU Xiaoyin, LI Hong, JIANG Yue. Study on water distribution uniformity of non-circular nozzles at low pressure. Journal of Drainage and Irrigation Machinery Engin, 2017, 35(5): 448-453.
[1]袁寿其,李红,王新坤. 中国节水灌溉装备发展现状、问题、趋势与建议[J]. 排灌机械工程学报, 2015, 33(1): 78-92. YUAN Shouqi, LI Hong, WANG Xinkun. Status, problems, trends and suggestions for water-saving irrigation equipment in China[J]. Journal of drainage and irrigation machinery engineering, 2015, 33(1): 78-92.(in Chinese)[2]DUKES M D, PERRY C. Uniformity testing of variable-rate center pivot irrigation control systems[J]. Precision agriculture, 2006, 7(3):205-218.[3]徐敏.旋转式喷头低压均匀喷洒的试验研究[D].镇江:江苏大学,2013.[4]宋卫臣. 安全阀类型和规格的选用[J]. 化工设备与管道, 2017, 54(1):82-86. SONG Weichen.Selection of type and size of safety valve[J].Process equipment & piping,2017, 54(1):82-86.(in Chinese)[5]李敬彬,李根生,黄中伟,等.多孔喷嘴能量转化效率分析[J].流体机械, 2017,45(1):20-25. LI Jinbin,LI Gensheng,HUANG Zhongwei,et al.Energy conversion efficiency of the multi-orificenozzle[J].Fluid machinery, 2017,45(1):20-25.(in Chinese)[6]黄晓庆, 张旭, 张东亮. 撞击型喷嘴雾化特性的试验研究[J]. 流体机械, 2016,44(4):1-3. HUANG Xiaoqing, ZHANG Xu,ZHANG Dongliang. Experimental study on the atomization characteristic of impingement-type nozzle[J].Fluid machinery, 2016,44(4):1-3.(in Chinese)[7]李一鸣. 旋转式低压喷头流道及阻尼机构优化设计研究[D].镇江:江苏大学,2015.[8]朱兴业,袁寿其,刘俊萍.低压条件下PY115型摇臂式喷头水力性能试验[J].农业机械学报,2011,42(11):76-80. ZHU Xingye,YUAN Shouqi,LIU Junping.Hydraulic performance of impact sprinkler type PY115 at low pressure[J]. Transactions of the CSAM,2011,42(11):76-80.(in Chinese)[9]LI H, YUAN S Q, XIANG Q J, et al. Theoretical and experimental study on water offset flow in fluidic component of fluidic sprinklers[J]. Journal of irrigation & drainage engineering, 2010, 137(4):408-409.[10]LI H, WANG C, CHEN C, et al. Study on the fluidic component of the complete fluidic sprinkler[J]. Advances in mechanical engineering, 2013, 2013(2013):143-148.[11]MCCARTHY M J, MOLLOY N A. Review of stability of liquid jets and the influence of nozzle design[J]. Chemical engineering journal, 1974, 7(1):1-20.[12]HASHIEHBAF A, ROMANO G P. Particle image velocimetry investigation on mixing enhancement of non-circular sharp edge nozzles[J]. International journal of heat & fluid flow, 2013, 44(44):208-221.[13]刘俊萍,袁寿其,李红.摇臂式喷头组合喷洒均匀性的改进[J]. 农业工程学报,2011,27(7):107-111. LIU Junping,YUAN Shouqi,LI Hong.Combination uniformity improvement of impact sprinkler[J].Transactions of the CSAE,2011,27(7):107-111.(in Chinese)[14]朱兴业,刘俊萍,袁寿其. 旋转式射流喷头结构参数及组合间距对喷洒均匀性的影响[J].农业工程学报,2013,29(6):66-72. ZHU Xingye,LIU Junping,YUAN Shouqi. Effect on sprayinguniformity based on geometrical parameters and combinedspacing of rotational fluidic sprinkler[J]. Transactions of the CSAE,2013,29(6):66-72.(in Chinese)