|
|
Fault diagnosis of 48 V micro hybrid system based on structural analysis |
1. Huibei Key Laboratory of Advanced Technology for Automotive Components, Wuhan University of Technology, Wuhan, Hubei 430070,China; 2. Hubei Collaborative Innovation Center for Automotive Components Technology, Wuhan, Hubei 430070, China; 3. Technology Center of Dongfeng Trucks, Wuhan, Hubei 430070, China |
|
|
Abstract The working principle of 48 V micro hybrid system and the structural analysis were introduced. The simulation model of 48 V micro hybrid system was established in Matlab/Simulink software to analyze the common failure modes of the sensors and synchronous belt transmission. Five minimal structurally overdetermined sets(MSO sets) corresponding to fault model of 48 V micro hybrid system were selected based on structural analysis (SA) to design the fault detection and isolation (FDI) system with fault eigenvectors of system defined by the diagnostic strategy. The simulation results show that compared with traditional methods, the diagnostic method based on structural analysis uses less residuals and can simply algorithm. The FDI system can use only five residuals to detect and isolate 10 kinds of system faults in 48 V micro-hybrid system, and all of them can be completely isolated from each other.
|
Received: 12 November 2018
|
|
|
|
[1] |
杨飞, 胡春明, 张必军. 48 V轻度混合动力系统控制策略的仿真研究[J]. 内燃机工程, 2017, 38(6):111-118.
|
|
YANG F, HU C M, ZHANG B J. Simulative research of control strategy for 48 V mild hybrid system[J]. Chinese Internal Combustion Engine Engineering, 2017, 38(6):111-118.(in Chinese)
|
[2] |
赵治国, 杨云云, 何露,等. 48 V微混HEV BOOST模式转矩瞬态优化控制[J]. 汽车技术, 2015(7):46-51.
|
|
ZHAO Z G, YANG Y Y, HE L, et al. Torque transient optimal control in boost mode of 48 V micro hybrid electric vehicle[J]. Automobile Technology, 2015(7):46-51.(in Chinese)
|
[3] |
MAGA M, RAMDANI N, TRAV-MASSUYS L. Robust fault detection in hybrid systems using set-membership parameter estimation[J]. IFAC Papers Online, 2015, 48(21):296-301.
|
[4] |
MEZIANE H, LABARRE C, LEFTERIU S, et al. Fault detection and isolation for a multi-cellular converter based on sliding mode observer[J]. IFAC Papers Online, 2015, 48(21):164-170.
|
[5] |
HWANG W, HUH K. Fault detection and estimation for electromechanical brake systems using parity space approach[J]. Journal of Dynamic Systems Measurement & Control, 2015, 137(1): 014504.
|
[6] |
CHRISTOFER S, ERIK F, LARS N. Selecting and utilizing sequential residual generators in FDI applied to hybrid vehicles[J]. IEEE Transactions on Systems Man & Cybernetics Systems, 2014, 44(2):172-185.
|
[7] |
ZHANG J Y, RIZZONI G. Functional safety of electrified vehicles through model-based fault diagnosis[J]. IFAC Papers Online, 2015, 48(15):454-461.
|
[8] |
CHEN Q, AHMED Q, RIZZONI G, et al. Design and evaluation of model-based health monitoring scheme for automated manual transmission[J]. Journal of Dynamic Systems Measurement & Control, 2016, 138(10): 101011.
|
[9] |
袁登科, 徐延东, 李秀涛. 永磁同步电动机变频调速系统及其控制[M]. 北京:机械工业出版社, 2015.
|
[10] |
陈奇, 姚志刚, Qadeer Ahmed,等. 基于结构分析法的故障诊断理论及其应用研究[J]. 汽车工程, 2017, 39(11):1341-1349.
|
|
CHEN Q, YAO Z G, AHMED Q, et al. A research on structural analysis-based fault diagnosis theory and its application[J]. Automotive Engineering, 2017, 39(11):1341-1349.(in Chinese)
|
[11] |
ZHANG J Y, RIZZONI G. Structural analysis for diagnosability and reconfigurability, with pplication to electric vehicle drive system[J]. IFAC Papers Online, 2015, 48(21):1471-1478.
|
[12] |
MATTIAS K, JAN , MATTIAS N.An efficient algorithm for finding minimal overconstrained subsystems for model-based diagnosis[J]. IEEE Transactions on Systems, Man, and Cybernetics Part A: Systems and Humans, 2007, 38(1):197-206.
|
|
|
|