|
|
Spray-wall impingement characteristics of GDI elliptical nozzle |
School of Automotive and Traffic Engineering, Jiangsu University, Zhenjiang, Jiangsu 212013, China
|
|
|
Abstract The internal flow and spraywall impingement characteristics of circular and elliptical GDI orifices were simulated by the VOFspray one way coupling method under different injection pressures. The results show that the mass flow rate of isooctane at the outlet of elliptical orifice is larger than that of circular orifice, and the mass flow rate of isooctane in elliptical orifice E2 with the aspect ratio of 4 is 3.54% larger than that of circular orifice under the injection pressure of 15.0 MPa. In the spray penetration stage, the spray penetration of elliptical orifice is always smaller than that of circular orifice, which delays the time when the spray impacts the wall. Under the injection pressure of 6.0 MPa, compared with the circular orifice, the spray impingement time of the elliptical orifice E2 is delayed by 0.14 ms. The impinged spray radius width and height width of the circular orifice are larger than those of the elliptical orifices after the impingement. This is because the circular spray has larger momentum, which promotes the splash and rebound of the impinged spray, while the difference between circular and elliptical orifices is decreased with the increasing of injection pressure.
|
Received: 17 March 2021
|
|
|
|
[1] |
DISTASO E, AMIRANTE R, TAMBURRANO P, et al. Understanding the role of soot oxidation in gasoline combustion: a numerical study on the effects of oxygen enrichment on particulate mass and number emissions in a sparkignition engine[J]. Energy Conversion and Management, 2019, 184:24-39.
|
[2] |
LIU Y, PEI Y Q, WANG C X, et al. Characteristics of the deposited fuel liquid film when GDI spray impacts viscous oil film[J]. Energy, doi: 10.1016/j.energy.2019.116011.
|
[3] |
王艳华, 杨世春, 李波, 等.汽油缸内直喷多孔喷油器喷雾碰壁特性试验[J].江苏大学学报(自然科学版),2013,34(4):390-394.
|
|
WANG Y H, YANG S C, LI B, et al. Experimental on impingement spray characteristics of multihole injector in gasoline direct injection engine[J]. Journal of Jiangsu University(Natural Science Edition),2013,34(4):390-394. (in Chinese)
|
[4] |
钱丁超,段加全,刘耀东,等.喷油压力对直喷汽油机燃油湿壁的影响分析及优化研究[J].小型内燃机与车辆技术,2017,46(1):22-27.
|
|
QIAN D C, DUAN J Q, LIU Y D, et al. Analysis and optimization on injection pressure influence on wall wetting of GDI engine[J]. Small Internal Combustion Engine and Vehicle Technique, 2017,46(1):22-27. (in Chinese)
|
[5] |
ZHOU Z F, MURAD S H M, TIAN J M, et al. Experimental investigation on heat transfer of npentane spray impingement on piston surface[J]. Applied Thermal Engineering, 2018,138:197-206.
|
[6] |
LUO H L, NISHIDA K, UCHITOMI S, et al. Microscopic behavior of spray droplets under flatwall impinging condition[J]. Fuel, 2018, 219:467-476.
|
[7] |
许贝, 裴毅强, 秦静,等.直喷汽油机附壁油膜特性试验研究[J].内燃机工程, 2019,40(5):38-45.
|
|
XU B, PEI Y Q, QIN J, et al. Experimental study on oil film characteristics of direct injection gasoline engine spray wall impingements[J].Chinese Internal Combustion Engine Engineering, 2019, 40(5): 38-45.(in Chinese)
|
[8] |
康灿,高可可,张永超.基于剪切效应的气动雾化喷嘴试验研究[J].排灌机械工程学报,2022,40(3):270-275.
|
|
KANG C, GAO K K, ZHANG Y C. Experimental study on pneumatic atomizing nozzle based on shear effect[J]. Journal of Drainage and Irrigation Machinery Engineering, 2022, 40(3):270-275.(in Chinese)
|
[9] |
裴娜,杨华,刘联胜, 等.喷孔结构对双旋流气泡雾化喷嘴喷雾特性的影响[J].流体机械,2021,49(9):1-5,12.
|
|
PEI N, YANG H, LIU L S, et al. Effect of orifice structure on spray characteristics of double swirl effervescent atomizer[J]. Fluid Machinery, 2021,49(9):1-5,12.(in Chinese)
|
[10] |
YU S H, YIN B F, DENG W X, et al. An experimental comparison of the elliptical and circular nozzles spray and mixing characteristics under different injection pressures[J]. Fuel, 2019, 236:1474-1482.
|
[11] |
MORAD M R, KHOSROBEYGI H. Penetration of elliptical liquid jets in lowspeed crossflow[J]. Journal of Fluids Engineering, 2019, 141(1):530-537.
|
[12] |
WAGER D. The influence of elliptical nozzle holes on mixing and combustion in direct injection natural gas engines[D]. Toronto, CAN: University of Toronto, 2008.
|
[13] |
AMINI G, DOLATABADI A. Axisswitching and breakup of lowspeed elliptic liquid jets[J]. International Journal of Multiphase Flow, 2012, 42:96-103.
|
[14] |
SAHA K, QUAN S P, BATTISTONI M, et al. Coupled Eulerian internal nozzle flow and Lagrangian spray simulations for GDI systems[C]∥SAE Technical Paper Series. Michigan, USA: Sae International, doi: 10.4271/2017-01-0834.
|
[15] |
QUAN S P, SENECAL P K, POMRANING E, et al. A oneway coupled volume of fluid and EulerianLagrangian method for simulating sprays[C]∥Proceedings of the ASME 2016 Internal Combustion Engine Fall Technical Conference. Greenville, USA:[s.n.], 2016:1-8.
|
[16] |
SAHA K, SOM S, BATTISTONI M. Investigation of homogeneous relaxation model parameters and their implications for gasoline injectors[J]. Atomization and Sprays, 2017, 27(4):345-365.
|
[17] |
WINKLHOFER E, KULL E, KELZ E, et al. Comprehensive hydraulic and flow field documentation in model throttle experiments under cavitation conditions[C]∥Proceedings of the ILASSEurope 2001.[S.l.]: International Conference on Liquid Atomization and Spray Systems, 2001:574-579.
|
|
|
|