|
|
|
| Test and analysis of abnormal vibration of vertical mixedflow pump |
| (1. School of Power and Mechanical Engineering, Wuhan University, Wuhan, Hubei 430072, China； 2. School of Mechanical and Electrical Engineering, Nanchang Institute of Technology, Nanchang, Jiangxi 330099, China) |
|
|
|
|
Abstract To identify the reasons for the abnormal vibration in a vertical mixedflow pump, the vertical and horizontal vibrations were measured at the low bracket, pump lid and outside column of pump unit by using lowfrequency vibration sensors in startup and normal operation periods, the pump shaft run out were monitored by means of an eddy current sensor as well. The experimental data were processed by the Hilbert-Huang transform (HHT), and the vibration peakpeak displacements were acquired, and the eigenvectors of vibration signals were extracted to diagnose the type of fault; finally, the timefrequency feature in startup period was analyzed in order to search the root reasons for the abnormal vibration. The analyzed results showed that the vibration frequency of the pump unit was close to the unit rotational frequency in the normal operation; additionally, for the shaft orbit is similar to an eccentric ellipse, the type of fault in the unit was unlikely the rotor imbalance. During the starting period, the shaft orbit was chaos and the vibration amplitude was as large as 47.3 times the amplitude in the normal operation, suggesting a violent force might be generated in the starting period and eventually induces the rotor to operate in imbalance. The timefrequency characteristics of vibration signals in a pump can be acquired accurately with the HHT, especially for highly nonlinear signals; meanwhile, this study on vibration generated in a pump during its startup period will provide a new way for pump troubleshooting.
|
|
Received: 29 November 2012
Published: 31 May 2013
|
|
|
|
| ［1］Albraik A,Althobiani F, Gu F,et al. Diagnosis of centrifugal pump faults using vibration methods［C］∥Proceedings of the 25th International Congress on Condition Monitoring and Diagnostic Engineering,2012.［2］孔繁余,王婷,张洪利.基于流场数值模拟的多级泵转子动力学分析［J］.江苏大学学报：自然科学版,2011,32(5):516-521.Kong Fanyu,Wang Ting,Zhang Hongli. Rotor dynamic analysis of multistage pump based on numerical simulation of flow field［J］. Journal of Jiangsu University: Natural Science Edition, 2011,32(5):516-521.(in Chinese)［3］赵鹏.离心泵振动故障诊断方法研究及系统实现［D］.北京：华北电力大学能源动力与机械工程学院,2011.［4］杨志荣.基于多源信息融合的水电机组故障诊断与轴心轨迹识别技术研究［D］.武汉：华中科技大学电气与电子工程学院,2011.［5］刘梅清,林琦,梁兴,等.泵站前池流态改善效果的数值模拟分析［J］.武汉大学学报：工学版,2012,45(2):152-156.Liu Meiqing,Lin Qi,Liang Xing, et al. Numerical simulation research on improving flow pattern of forebay of a pumping station［J］. Engineering Journal of Wuhan University,2012, 45(2):152-156.(in Chinese)［6］Ricci R, Pennacchi P. Diagnostics of gear faults based on EMD and automatic selection of intrinsic mode functions［J］.Mechanical Systems and Signal Processing,2011, 25(3):821-838.［7］Henríquez P, Alonso J B, Ferrer M A,et al. Fault diagnosis using audio and vibration signals in a circulating pump［C］∥Proceedings of the 25th International Congress on Condition Monitoring and Diagnostic Engineering,2012.［8］Seryasat O R, Aliyari S M, Honarvar F, et al. Multifault diagnosis of ball bearing using intrinsic mode functions, Hilbert marginal spectrum and multiclass support vector machine［C］∥Proceedings of the ICMEE 2010—2010 2nd International Conference on Mechanical and Electronics Engineering.Kyoto:［s.n.］,2010,2:2145-2149.［9］Abouhnik A, Albarbar A.Wind turbine blades condition assessment based on vibration measurements and the level of an empirically decomposed feature［J］. Energy Conversion and Management,2012,64:606-613.［10］国家质量监督检验检疫总局.GB/T60755—2002.在非旋转部件上测量和评价机器的机械振动第5部分:水力发电厂和泵站机组［S］.北京:中国标准出版社，2002. |
|
|
|
