|
|
|
| Analysis on flow characteristic of flatwalled diffusers applied in valveless piezoelectric pumps |
| HE Xiu-Hua, ZHUO Hong-Cai, YANG Song, DENG Zhi-Dan, Li-Fu |
（1.School of Energy and Power Engineering, Jiangsu University, Zhenjiang, Jiangsu 212013, China; 2.Faculty of Science, Jiangsu University, Zhenjiang, Jiangsu 212013, China） |
|
|
|
|
Abstract The flow in a tube with the narrowest width 150 μm and the depth 150 μm was studied numerically, two flow resistance coefficient curves versus cone angle θ and lengthwidth ratio l/w were obtained when the tube was subject to convergent and divergent flows at a Reynolds numbers ranged in 100-2 000. The results show that the smaller the cone angle θ, the more significantly dependent on θ and l/w the flow resistance coefficient λ, and a transition occurs in flow resistance feature. The relations of λ to θ and l/w are different at Re=100 and Re≥500 obviously. When Re=100, most of tubes present the typeⅠ tube characteristics that flow resistance coefficient in the divergent direction is less than in the convergent one, and λ reaches a maximum 1.22 at θ=20°and l/w=20. When Re≥500, most of tubes show the type Ⅱ tube characteristics which is contrary to typeⅠ, and λ reaches a minimum 0.63 at θ=20°and l/w=1. The results show that the flow resistance coefficient of flatwalled diffusers highly depends on Reynolds number. In order to improve performance of the valveless piezoelectric pump, appropriate geometrical parameters should be chosen in the pump design according to the actual working condition of the pump.
|
|
Received: 14 February 2012
Published: 30 September 2012
|
|
|
|
| ［1］Arvind Chandrasekaran, Muthukumaran Packirisamy. Geometrical tuning of microdiffuser/nozzle for valveless micropumps\[J\]. Journal of Micromechanics and Microengineering, 2011, 21(4)：045035.［2］Wang Yichun, Hsu Juicheng, Kuo Pingchi. Loss characteristics and flow rectification property of diffuser valves for micropump applications\[J\]. International Journal of Heat and Mass Transfer, 2009, 52: 328-336.［3］Ha DongHo, Van Phuoc Phan, Nam Seo Goo. Threedimensional electrofluid structural interaction simulation for pumping performance evaluation of a valveless micropump\[J\]. Smart Materials and Structures, 2009,18: 104015.［4］何秀华，邓许连，毕雨时，等.压电无阀微混合器的数值模拟\[J\].排灌机械工程学报，2011, 29（4）：292-296.He Xiuhua, Deng Xulian, Bi Yushi, et al. Numerical simulation for piezoelectric valveless micropump\[J\]. Journal of Drainage and Irrigation Machinery Engineering，2011,29（4）：292-296.（in Chinese）［5］Izzo I, Accoto D, Menciass A, et al. Modeling and experimental validation of a piezoelectric micropump with novel nomovingpart valves \[J\]. Sensors and Actuators A: Phyical, 2007,133: 128-140.［6］张建辉，黎毅力，夏齐霄. “Y”形流管无阀压电泵流量及流管流阻特性分析\[J\].机械工程学报， 2007,43(11):136-141.Zhang Jianhui, Li Yili, Xia Qixiao. Analysis of the pump volume flow rate and tube property of the piezoeclectric valveless pump with Yshape tubes\[J\]. Chinese Journal of Mechanical Engineering, 2007, 43(11)：136-141.（in Chinese）［7］何秀华，张睿.“V”型无阀压电泵理论分析与数值模拟 \[J\].排灌机械，2008，26（4）:30-34.He Xiuhua, Zhang Rui. Theoretical analysis and numerical simulation of valveless piezoelectric pump with Vshape tube \[J\]. Drainage and Irrigation Machinery, 2008, 26(4): 30-34. （in Chinese）［8］ Anders Olsson, Goran Stemme, Erik Stemme. Numerical and experimental studies of flatwalled diffuser elements for valveless micropumps \[J\]. Sensors and Actuators A: Phyical, 2000, 84: 165-175.［9］何永森，刘绍英.机械管内流体数值预测\[M\].北京：国防工业出版社，1999：91-98.［10］Gravesen P, Branebjeng J, Jensen O S. Microfluidics：A review \[J\]. Journal of Micromechanics and Microengineering, 1993, 3(4): 168-182. |
|
|
|
