|
|
Effects of axial gap of impeller side cavity on pressure and leakage in balance chamber in centrifugal pump |
LIU Zailun1,2, ZHOU Jinxin1*, CHEN Xiaochang1 |
1.College of Energy and Power Engineering, Lanzhou University of Technology, Lanzhou, Gansu 730050, China; 2.Wenzhou Valve Engineering Research Institute, Lanzhou University of Technology, Wenzhou, Zhejiang 325105, China |
|
|
Abstract In order to study influences of axial gap of impeller side cavity on pressure and leakage in the balance chamber of a centrifugal pump, the turbulent flows in the IS80-50-315 centrifugal pump were numerically simulated by using the RNG k-ε turbulence model when the axial gaps of impeller side cavity in the pump were 1, 4, 8, 12, 16 and 20 mm, respectively. The pressure distribution rules and variations of leakage with the gap size in the balance chamber were analyzed. An empirical formula of leakage was established based on the discharge coefficient, which was related to the dimensionless axial gap and the flow resistance coefficients across the side cavity, wear-ring gap and balance holes, respectively. The empirical relationship was applicable for the leakage prediction when the dimensionless axial gap was in a range of 0.006-0.127. It was found that the pressure in the balance chamber increased with increasing axial gap, especially for the gap in the range of 4 -16 mm. A little variation in the pressure was shown at the inlet of balance holes. The pressure on the wall of lid decreased with increasing cavity gap, but this phenomenon was not more obvious when the axial gap was 1 mm and 12 mm. Under the same working condition, the leakage increased with increasing axial gap. At a fixed axial gap, however, the leakage decreased with increasing pump flow rate.
|
Received: 18 September 2016
|
|
|
|
[1]GUINZBURG A,BRENNEN C E,ACOSTA A J,et al.Experimental results for the rotor dynamic characteristics of leakage flows in centrifugal pumps[J].Journal of fluids engineering,1994,116(1): 110-115.[2]BASKHARONE E A, DANIEL A S, HENSEL S J. Rotor dynamic effects of the shroud-to-housing leakage flow in centrifugal pumps[J].Journal of fluids engineering,1994,116(3):558-563.[3]张景,谈明高,刘厚林,等. 密封口环磨损对离心泵外特性及内流场的影响[J]. 排灌机械工程学报,2017,35(10): 849-855. ZHANG Jing,TAN Minggao,LIU Houlin,et al. Effects of wear-ring abrasion on hydraulic characteristic and internal flow field of centrifugal pump[J]. Journal of drainage and irrigation machinery engineering,2017,35(10): 849-855.(in Chinese)[4]MORGAN N R, UNTAROIU A, MIGLIORINI P J, et al. Design of experiments to investigate geometric effects on fluid leakage rate in a balance drum seal[J]. Journal of engineering for gas turbines and power, 2015, 137(3): 032501.[5]吴大转, 许斌杰, 武鹏, 等. 多级离心泵内部间隙流动与泄漏损失[J]. 浙江大学学报(工学版), 2011, 45(8): 1393-1398. WU Dazhuan, XU Binjie, WU Peng, et al. Internal clearance flow and leakage loss in multistage centrifugal pump[J]. Journal of Zhejiang University(engineering science), 2011, 45(8): 1393-1398.(in Chinese)[6]何玉杰,李辉,李跃,等.不同导叶叶片数对离心泵径向力的影响[J].化工设备与管道,2016,53(4): 46-50. HE Yujie, LI Hui, LI Yue, et al. Effect of guide vane number to radial force in centrifugal pump[J]. Process equipment & piping, 2016, 53(4):46-50.(in Chinese)[7]董玮,楚武利.平衡孔直径对离心泵性能及平衡腔压力的影响[J].农业机械学报,2015,46(6):73-77. DONG Wei, CHU Wuli. Influence of balance hole diameter on performance and balance chamber pressure of centrifugal pump[J]. Transactions of the CSAM,2015,46(6):73-77.(in Chinese)[8]魏清顺,刘在伦.基于 CFD 的离心泵浮动叶轮平衡腔压力数值分析与验证[J].中国电机工程学报,2011, 31(14): 103-107. WEI Qingshun, LIU Zailun. Numerical analysis and validation of floating impeller balance chamber pressure in centrifugal pump based on CFD[J].Proceedings of the CSEE,2011,31(14): 103-107.(in Chinese)[9]刘在伦,王东伟,梁森.离心泵叶轮平衡孔液体泄漏量特性试验[J].农业机械学报,2012,43(7):84-88. LIU Zailun,WANG Dongwei,LIANG Sen. Fluid leakage characteristic test on balance aperture of centrifugal pump impeller[J].Transactions of the CSAM,2012,43(7): 84-88.(in Chinese)[10]范宗霖,吴立军,黄志杰.泵腔对低比速叶片泵性能的影响[J].水泵技术,2005(4):1-2,26 FAN Zonglin, WU Lijun, HUANG Zhijie. Impact of pump cavity for low-speed vane pump′s performance [J]. Pump technology, 2005(4): 1-2, 26.(in Chinese)[11]张杰, 赵波, 李金国. 基于 CFD 的汽车水泵数值模拟与试验验证[J]. 流体机械, 2016, 44(11):6-10. ZHANG Jie,ZHAO Bo,LI Jinguo. Numerical simulation and test verification of automotive water pump based on CFD [J].Fluid machinery,2016,44(11): 6-10.(in Chinese)[12]李广府,赖喜德,张惟斌,等.双吸离心泵中叶轮轴向窜动对水力性能影响分析[J].中国农村水利水电,2012(5):129-132. LI Guangfu, LAI Xide, ZHANG Weibin, et al. An analysis of the influence on hydraulic performance as axial moving of impeller inside a double-suction centrifugal pumps[J].China rural water and hydropower,2012(5):129-132.(in Chinese)[13]刘在伦,吴佼,曾继来,等.浮动叶轮轴向位移量对泵水力性能的影响[J].兰州理工大学学报,2015,41(2): 51-54. LIU Zailun, WU Jiao, ZENG Jilai, et al. Influence of axial displacement of floating impeller on hydraulic performance of pump[J]. Journal of Lanzhou University of Technology,2015,41(2): 51-54.(in Chinese)[14]刘在伦, 孙雨, 王东伟, 等. 离心泵泵腔流道液体泄漏量试验与计算方法[J]. 农业机械学报, 2015, 46(6): 97-101. LIU Zailun,SUN Yu,WANG Dongwei,et al. Experiment and calculation method of fluid leakage in flow passage of pump chamber on centrifugal pump[J]. Transactions of the CSAM,2015,46(6): 97-101.(in Chinese)[15]刘在伦,董玮,张楠,等.离心泵平衡腔液体压力的计算与验证[J].农业工程学报,2013,29(20): 54-59. LIU Zailun, DONG Wei, ZHANG Nan, et al. Calculation and validation of fluid pressure of balance cavity in centrifugal pump[J]. Transactions of the CSAE, 2013, 29(20): 54-59.(in Chinese)[16]沙毅. 旋涡泵内部流动分析及水力设计[J]. 流体机械, 2016, 44(12):29-32. SHA Yi. Interior flow analysis and hydraulic design method of vortex pump[J]. Fluid machinery,2016, 44(12):29-32.(in Chinese)[17]关醒凡.现代泵理论与设计[M]. 北京: 中国宇航出版社,2011. |
|
|
|