Abstract:Four energy recovery hydraulic turbine models were designed according to different combinations of guide vane inlet and outlet angles based on an existing single-stage centrifugal volute pump, and the fluid flows in them were simulated numerically by using software Fluent 6.3. It was shown that at the same flow rate all the turbine efficiency and head were declined markedly with increasing inlet angle; at the best efficiency point(BEP), however, the hydraulic efficiency of model A was 7% hi-gher than that of model D. For the same inlet angle, once the outlet angle was greater than the inlet angle, the circulation at the guide vane outlet was decreased and the efficiency of turbine was reduced; otherwise, the efficiency was raised. With increasing inlet and outlet angles, BEP was moved to a higher flow rate, and the pressure distribution in the impeller was distributed more non-uniformly. Therefore, the inlet angle plays a crucial role in determining turbine performance and a guide vane with an inlet angle larger than the outlet angle is beneficial to turbine efficiency. Especially, for a turbine in which the basic geometrical parameters of all the hydraulic components except the guide vane were fixed, there is an optimum combination between inlet and outlet angles of the guide vane. This result can provide some theoretical basis for further study on energy recovery hydraulic turbines.
史凤霞, 杨军虎, 王晓晖. 导叶进出口角对能量回收水力透平性能的影响[J]. 排灌机械工程学报, 2014, 32(5): 378-381.
Shi Fengxia, Yang Junhu, Wang Xiaohui. Effect of guide vane inlet and outlet angles on performance of energy recovery turbines. Journal of Drainage and Irrigation Machinery Engin, 2014, 32(5): 378-381.
[1]龚时宏.水泵作为水轮机运行时的选型[J].小水电,1989(5):25-27. Gong Shihong. Type selection for pump operating as hydroturbine[J]. Small Hydropower, 1989(5):25-27.(in Chinese)[2]Ramos H, Borga A. Pumps as turbines: An unconventional solution to energy production[J]. Urban Water, 1999,1(3), 261-263.[3]杨军虎,张雪宁,王晓晖,等.能量回收液力透平研究综述 [J].流体机械,2011,39(6):29-33. Yang Junhu,Zhang Xuening,Wang Xiaohui, et al. Overview of research on energy recovery hydraulic turbine[J].Fluid Machinery, 2011,39(6):29-33.(in Chinese)[4]Shahram Derakhshan,Ahmad Nourbakhsh. Experimental study of characteristic curves of centrifugal pumps wor-king as turbines in different specific speeds[J]. Experimental Thermal and Fluid Science, 2008,32(3):800-807.[5]Punit Singh, Franz Nestmann. Internal hydraulic analysis of impeller rounding in centrifugal pumps as turbines[J]. Experimental Thermal and Fluid Science, 2011,35(1): 121-134.[6]杨军虎,袁亚飞, 蒋云国,等. 离心泵反转作为能量回收透平的性能预测[J], 兰州理工大学学报, 2010,36(1):54-56. Yang Junhu, Yuan Yafei, Jiang Yunguo,et al.Perfor-mance predictions of reversed centrifugal pumps working as energy recovery turbines[J].Journal of Lanzhou Uni-versity of Technology, 2010,36(1), 54-56.(in Chinese) [7]杨孙圣,孔繁余,邵飞,等.液力透平的数值计算与试验[J].江苏大学学报:自然科学版,2012,33(2),165-169. Yang Sunsheng,Kong Fanyu,Shao Fei,et al.Numerical calculation and experiment of hydraulic turbine[J]. Journal of Jiangsu University:Natural Science Edition, 2012,33(2), 165-169.(in Chinese)[8]Punit Singh, Franz Nestmann. An optimization routine on a prediction and selection model for the turbine opera-tion of centrifugal pumps[J]. Experimental Thermal and Fluid Science, 2010, 34(2):152-164.[9]Antwerpen van H J, Greyvenstein G P. Use of turbines for simultaneous pressure regulation and recovery in se-condary cooling water systems in deep mines[J].Energy Conversion and Management,2005,46(3):563-575.[10]Pradeep Bansal,Nick Marshall. Feasibility of hydraulic power from waste energy in bio-gas scrubbing process[J]. Applied Energy,2010,87(3):1048-1053.[11]Shahram Derakhshan, Bijan Mohammadi, Ahmad Nourbakhsh. Efficiency improvement of centrifugal reverse pumps[J]. Journal of Fluids Engineering,2009,131(2):103-111.[12]Ventrone G, Ardizzon G, Pavesi G. Direct and reverse flow conditions in radial flow hydraulic turbomachines[J].Proc Instn Mech Engrs:Part A,2000,214(6):635-644.[13]Ferandez J,Blance E. Performance of centrifugal pump running in inverse mode[J].Journal of Power and Energy, 2010,18(4):265-271.[14]曹鹍,姚志民. 水轮机原理及水力设计[M].北京:清华大学出版社,1991.